Expert Painters

Repaint or Reclad: Making the Call on Weatherboards

Weatherboard house painting and timber repair in Melbourne

At some point on an older weatherboard home the question stops being what colour and becomes repaint or reclad. It usually arrives when a painter points at the bottom boards on the south side and says they will not hold paint again.

This is a decision worth making deliberately, because the two paths cost very different amounts and solve very different problems.

What a repaint fixes, and what it does not

Repainting restores the protective film. It seals the timber against water, blocks UV, and makes the house look cared for. Done properly it buys another eight to twelve years on most elevations.

What it cannot do is restore timber that has already gone. Paint is a coating, not a structural product. If a board is soft, split through, cupped badly or rotted at the end grain, paint over it is cosmetic and temporary — it will fail in the same spot, usually within two or three years, because the moisture is coming from inside the board rather than landing on it.

The useful question is therefore not how the paint looks. It is how much of the timber underneath is still sound.

Signs the boards themselves are finished

Walk the perimeter and look specifically at the lower third of each wall, the ends of boards where they meet corners, and anywhere a downpipe or garden bed sits close.

  • Timber that gives when you press it with a screwdriver, particularly at board ends.
  • Rot at the bottom edge, where water sits on the lap.
  • Boards that have cupped or twisted enough that the lap no longer sits flat.
  • Splits running with the grain that open and close seasonally.
  • Paint that has failed in the same spots two repaints running.
  • Daylight or draughts visible from inside at board junctions.
  • Boards that have been face-nailed repeatedly and are now splitting around the fixings.

Scattered examples are normal maintenance. Replacing a dozen boards on a hundred-year-old house is routine carpentry and does not change the decision.

Repaint or reclad: where the economics turn

The useful threshold is the proportion of boards needing replacement rather than any single defect.

Below roughly 10 to 15 per cent, repair and repaint is almost always the better value. The carpentry is modest, the new boards get primed on all faces including the end grain, and the whole thing gets painted as one.

Once you are replacing something approaching a third of the boards on an elevation, the sums shift. You are paying for carpentry, for timber, for making good, and then for a full paint job on top of it — and you still have two-thirds original boards that will come due in the next cycle. At that point recladding that elevation often costs little more and resets the clock entirely.

This is why repaint or reclad is frequently answered per elevation rather than per house. The south and west walls fail first; the north and east may have another fifteen years in them. Recladding one elevation and repainting the rest is a completely legitimate answer and often the most economical one.

What recladding involves that people underestimate

Taking cladding off is not just a cladding job. Once the boards are off you can see the frame, and what you find determines the real cost.

  • Any rot in the studs or bottom plate has to be addressed before anything goes back on.
  • Most pre-1980s Melbourne homes have no sarking and no insulation in the walls. With the cladding off, both become straightforward to add, and that is the single best opportunity you will ever get to insulate the walls.
  • Window and door flashings are usually original and often the reason the rot happened. They should be replaced while access is there.
  • Services — old wiring, redundant pipework — become visible and accessible.

The insulation point is worth dwelling on. Retrofitting wall insulation without removing cladding means drilling and blowing in, which is less effective and more invasive. If the boards are coming off anyway, doing it then costs comparatively little.

Replacement cladding options and what each means for painting

  • Primed pine weatherboard. Matches the look of the original most closely, takes paint well, needs painting on a normal cycle. The traditional choice on a period home.
  • Hardwood weatherboard. Durable and in keeping on older homes, but expect tannin bleed issues and the need for an oil or shellac-based primer on the first coat.
  • Fibre cement weatherboard. Dimensionally stable, does not rot, takes paint very well and holds it longer than timber because it does not move with moisture. Reads slightly flatter than timber up close.
  • Pre-finished fibre cement or composite. Factory-coated, so no painting initially. Long warranty on the finish, but colour choice is limited to the range and touch-ups are harder to match later.

A point people miss: pre-finished products are not maintenance-free, they are maintenance-deferred. In fifteen or twenty years they will need painting like anything else, and at that point you are back to a normal repaint cycle.

The constraint that can decide it for you

If your home is in a heritage overlay, recladding may not be an option, or may only be permitted in the original material and profile. This applies across large parts of Fitzroy, Carlton, Richmond, South Melbourne, Williamstown and the older bayside suburbs.

Overlays generally care about what is visible from the street. A rear elevation is often treated differently from a front facade. Check with your council before you plan anything, because discovering the constraint after you have budgeted is an expensive surprise.

There can also be an asbestos question. Some mid-century homes have asbestos cement cladding that looks like weatherboard from a distance, and that changes the job entirely — it cannot be sanded, cut or removed without a licensed process.

When one more repaint is the right answer

Sometimes it is, and it is worth saying so.

If you are selling within a couple of years, a careful repair-and-repaint presents well and costs a fraction of recladding. If the timber is sound and the problem is that the last paint job was done badly — no primer on end grain, painted over damp boards, the wrong product — then the fix is doing it properly this time, not replacing good timber.

And if the failures are concentrated around a single cause, such as a blocked gutter that has been soaking one corner for years, fixing the cause and repairing locally is the sensible move.

Get the timber assessed before you decide

We check the boards rather than the paint, elevation by elevation, and tell you what proportion actually needs replacing. That proportion, not the state of the paint, is what should decide repaint or reclad. Call 0404 330 332 and we will come and go over it with you.

📍 Our Service Areas Across Melbourne, the Mornington Peninsula, Surf Coast & Phillip Island

Melbourne & Bayside

Phillip Island & Bass Coast

Surf Coast & Bellarine Peninsula

Related Posts

Leave a Reply

Your email address will not be published. Required fields are marked *